Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - PPRINT

Pages: [1]
1
Driveline / Re: MST 205 507b - help finding information
« on: January 21, 2021, 05:23:27 am »
I think this link will get you where you need to go.

If not you can google "tecumseh technician's transmissionhandbook" look for a link to the PDF version.

https://www.mymowerparts.com/pdf/Tecumseh-Service-and-Repair-Manuals/TECUMSEH-PEERLESS-TRANSMISSION-TRANSAXLES-DIFFERENTIALS-SERVICE--REPAIR-MANUAL-691218.pdf

Rob

2
Rodney,
Thanks for the info. 

Do you have the part numbers for a steel pinion gear and ring gear for 700 trans?

Thank you,
Rob

3
Briggs OHV & Vanguard / Re: GP fell flat on its face!
« on: June 24, 2020, 10:15:48 pm »
A carb running to rich or to lean will also do this.  A motor reving under no load has a different jetting requirement once under load.

I found this document on a FB group for calibrating the low speed side of the carb.  I couldn't get my wife's GP/T mower to come off the corner clean and it would pop and shart all the way down the straight and never reach full sing.  The tuning instructions at the bottom of that page led me to realize my idle jet was too lean and once resolved I could get it to the governor no problem.  Now to learn more about main jets.

Your results may very.

Rob




Pages: [1]