Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - racingjohndeere55

Pages: 1 ... 37 38 [39]
Briggs OHV & Vanguard / Re: 44CID Intek
« on: July 31, 2009, 09:06:31 am »
I will do that, Thank ya :)

Briggs OHV & Vanguard / Re: intek ARC flywheel/Stock Starter Problem
« on: July 31, 2009, 09:05:03 am »
The folks at ARC told me that I had to have the heavy duty starter to run with their flywheels. So after I spent the 250.00 bucks on it I am unpacking it at the garage, Mark (Parts manager at a local John Deere dealer) looks at it and said to me that it is just a stock heavyduty starter from Briggs. I dont know what the number is, but I will reserch it and let you know.

Briggs OHV & Vanguard / Re: E.c. Air filter for intek
« on: July 31, 2009, 08:52:38 am » I use the stock shaped one. 33-2240 I think it keeps a nice stock appearance of the engine, and its a easy install.....

Briggs OHV & Vanguard / Re: 44CID Intek
« on: July 31, 2009, 08:39:56 am »
Do I just need a higher lift, or do I need a longer duration too? :bash: I have to explane this to my sponsor "aka" Mrsracingjohndeere55 :3gears: I found out if I get real technical she just kinda looks at me and says "ok"

Briggs OHV & Vanguard / Re: 44CID Intek
« on: July 29, 2009, 01:52:10 pm »
My 44 runs with the indians. I watch George run past me all the time......... George, Since I run a lower rpm than most, is there a cam avalable to work with the lower rpm's?

Pages: 1 ... 37 38 [39]