1
Newcomers / Re: Model 40 connecting rods
« on: September 18, 2023, 10:13:23 am »
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
Newcomers / Re: Model 40 connecting rods
« on: June 16, 2023, 02:33:10 pm »
Cast aluminum, the aftermarket like from ARC or EC carb are billet.
3
Newcomers / Re: Model 40 connecting rods
« on: June 13, 2023, 10:10:41 am »
Unless you want a ventilated block I would put billet rods in it. Stockers are only good to 3650 rpm's.
4
Briggs OHV & Vanguard / Re: Billet dogbone no longer available ?
« on: May 24, 2023, 09:00:14 am »
It shouldn't. I would be concerned about the connecting rod, and the flywheel. Steel would defiantly be stronger!
5
Newcomers / Re: Montana HS Club
« on: December 07, 2022, 03:44:24 pm »
Bring on the questions! Lots of knowledge around here!
6
Chassis / Re: Motorcycle brake disc on transaxle stub
« on: December 07, 2022, 03:41:37 pm »
It's been said "keep it simple" I believe it applies here also.
7
Newcomers / Re: New Family Race Team
« on: December 07, 2022, 03:37:18 pm »
Most rules say where the engine goes! And that usually is the stock location. There is not much room to move things around a lot, so it probably won't make a lot of difference.
8
Coffee Shop / Re: What if......
« on: December 07, 2022, 03:33:07 pm »
Yes that is from here! The lawnmower racing is winding down. Not sure why, it's a low cost form of competitive motorsports. Plus it's fun! Facebook came along just to keep up with the times.
Here in Michigan we only have one track left, and that really is sad.
Here in Michigan we only have one track left, and that really is sad.
10
Briggs Flathead / Re: No spark from Alloy flywheel
« on: December 07, 2022, 03:20:41 pm »
The magnet might have to much clearance. I didn't know you can change magnets on a flywheel like that. That concerns me that the magnet could come apart. Be very careful with that.
11
Coffee Shop / Re: Where?s everyone at??
« on: September 23, 2022, 10:37:20 am »
When George Herrin passed this place got quiet, when Bert passed it got a lot quieter. Yes you both are correct this is a great place to learn, sell stuff, and have a good time!
12
Driveline / Re: Looking to buy a heavy duty centrifugal clutch
« on: April 08, 2022, 10:28:00 am »
Good luck finding one with a 5" pulley. You're going to have to get creative for that!
13
Coffee Shop / Re: Kawasaki engines
« on: March 12, 2022, 11:18:58 am »
I do have some performance stuff for the 460 flathead if your interested.
14
Mower Engines & Parts / Re: Raceing cam for Briggs model 28
« on: February 26, 2022, 08:51:29 am »
There you go, Paul can help you find anything you need!
15
Want To Buy / Who Has It? / Re: does anyone have a full pressure lube 42 or 46ci briggs opposed block
« on: January 27, 2022, 05:23:11 pm »
I have a oil pump pan for a OPPY.