Heymow - Lawnmower Racing Forum

Engine Help => Briggs Flathead => Topic started by: Dave Fires on November 06, 2005, 09:37:58 pm

Title: Briggs 28 Build Up HELP
Post by: Dave Fires on November 06, 2005, 09:37:58 pm

Hello Fellas,  I am about to start rebuilding my motor (Briggs 28ci) and am planning on putting all the expensive Goodies in it ( billet flywheel, ARC rod, piston, rings, valves and keepers) .
   I was wondering if anyone replaces valve guides, seats, or crank bearings on 28ci series engines ? If so, where could I get it done or who would you recommend ? OH yeah and can anyone tell me what valves and springs to buy and info on cuttin the groove for the keepers or do anyone sell them ready to install. (I already have the G-Force cam)

Any help would be very much appreciated ! :roll:

Title: Briggs 28 Build Up HELP
Post by: George Herrin on November 06, 2005, 10:49:12 pm

I can do all your block work, valve work and set you up with spring also. If interested email me gdherrin@bellsouth.net.
George