Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Schiveley89

Pages: [1]
1
Driveline / 35 chain
« on: July 27, 2021, 11:10:36 pm »
Does anyone run #35 chain in the front and back on a horizontal engine with a jack shaft? Just wondering

2
Briggs OHV & Vanguard / Stroker vanguard
« on: July 22, 2021, 12:38:29 am »
Can you make a vanguard twin a stroker engine? What's it all intel? I have a 18hp..35 cube

3
Briggs OHV & Vanguard / Briggs vanguard elbow two barrel
« on: July 07, 2021, 10:43:18 pm »
Looking for a elbow for vanguard...690925..can't find one anywhere!! For two barrel

4
Briggs OHV & Vanguard / Cheetah cam push rods
« on: June 20, 2021, 04:41:57 pm »
Have any of you bought a cheetah cam and the billet pushrods from cartpartsplus.com?
And will that cam accept stock length push rods?

Vanguard 18 horizontal

5
Chassis / Re: Help with gearing
« on: June 06, 2021, 07:50:59 pm »
Paul,my last one was a 5:1
It went...15 to 30 then
16-48

Now it's a smaller track,150-180' straights..clutch will most likely be a 15 tooth
Any sprocket tooth ideas?
Horizontal Briggs twin

6
Chassis / Help with gearing
« on: June 04, 2021, 04:27:47 pm »

Looking for help on getting a base line set up for my gearing on my fx mower. Vanguard 35 built,pushing 6500 rpm,noram star clutch 15 tooth
1/10 mile track,8" rear wheel ,need that middle speed and torque set up.

7
Driveline / Help with gearing,modified with Briggs twin
« on: June 04, 2021, 03:17:22 pm »
Looking for help on getting a base line set up for my gearing on my fx mower. Vanguard 35 built,pushing 6500 rpm,noram star clutch 15 tooth
1/10 mile track,8" rear wheel ,need that middle speed and torque set up.

Pages: [1]
anything