Author Topic: Briggs 28 Build Up HELP  (Read 6347 times)

0 Members and 1 Guest are viewing this topic.

Offline Dave Fires

  • Newbie
  • *
  • Posts: 85
  • Karma: 1
  • Gender: Male
  • I'm not sure a grown man should have this much fun
    • View Profile
Briggs 28 Build Up HELP
« on: November 06, 2005, 09:37:58 pm »
Hello Fellas,  I am about to start rebuilding my motor (Briggs 28ci) and am planning on putting all the expensive Goodies in it ( billet flywheel, ARC rod, piston, rings, valves and keepers) .
   I was wondering if anyone replaces valve guides, seats, or crank bearings on 28ci series engines ? If so, where could I get it done or who would you recommend ? OH yeah and can anyone tell me what valves and springs to buy and info on cuttin the groove for the keepers or do anyone sell them ready to install. (I already have the G-Force cam)

Any help would be very much appreciated ! :roll:
Dave Fires
K & G Racing
S/P B/P # 402

Offline George Herrin

  • aka SUPERMAN
  • Superman
  • Highly Mowtivated
  • *
  • Posts: 17732
  • Karma: 102
  • Gender: Male
  • I am going to Race Every Race like its my last one
    • View Profile
    • BTMRA Home/Forum An Independant Club.
Briggs 28 Build Up HELP
« Reply #1 on: November 06, 2005, 10:49:12 pm »
I can do all your block work, valve work and set you up with spring also. If interested email me
George Herrin #6
Indian Power.. You gotta Go big to beat em or Go HOME
8 time ARMA National Champion
4 time USLMRA National Champion
Retired from BP
My other racer is a 1/5th scale Dirt Late Model!!!!